The leatherette, I forgot to mention. It is simple to remove, but do so with clean hands or a glove on with no powder on it. The covering is a self stick type. start from the outside in. On the advance side, you start peeling near the hinge and slow lift to the time/preview lever. Lift up from the bottom first and clear over towards the lever. It may require you push and activate the timer to slightly angle to clear off the cover. The other side is more straight forward, but gently lift around the terminals to clear the delicate strip between the terminals. Also, do the wrestling with the leatherette while the film door is still attached or you may put a finger through the shutter curtain.
About Me
- MysteryOnion
- Questions, but don't want others to see? Sure, send me an email... please, only questions about the content. Yes, complaints too. Yes, I know, my picture... I look like I'm dead... very sick at the time and I hate having my picture taken. mysteryonion@gmail.com
Popular Posts
-
Two broken or not working ME Supers... I will have to get on with the job and document and CLA both of them soon. For my repair pals that... -
...so while they hang up and dry, I'll put up the last of the opening desolders. We are almost to the point of removing the face. ... -
SURVEY: Should I move these ME Super Project notes to a separate blog? This was suggested by a rare write-in viewer. So, how do you ... -
So the next bit is the "Relay P. C." This part is connected to the speed buttons. The required first thing is to remove the t... -
A question from "Mike"... Inside a 67 200mm f4.0... sad thing is that I don't have one yet... however, we can at least get... -
This is the thing... I started with the camera with the fewer symptoms and hope that once the problems are fixed that it will be closed up...
-
A closer look at the "Winding Guide Plate Assembly"... Indicated is what was corrected. The function it provides is to move, ... -
One out of three... Although the service manual indicates removing the three wires, I opt to only do the one gray wire on the right as n... -
So with some coaxing the face of it falls off. As you can see, busy in there. Camera 1 will be just a basic gooey bumper and some clea... -
to orient, we are looking from the front just over the strap lug of the crank side. Not critical to the operation of the camera, but a ...
No comments:
Post a Comment