About Me
- MysteryOnion
- Questions, but don't want others to see? Sure, send me an email... please, only questions about the content. Yes, complaints too. Yes, I know, my picture... I look like I'm dead... very sick at the time and I hate having my picture taken. mysteryonion@gmail.com
Popular Posts
-
Two broken or not working ME Supers... I will have to get on with the job and document and CLA both of them soon. For my repair pals that... -
...so while they hang up and dry, I'll put up the last of the opening desolders. We are almost to the point of removing the face. ... -
SURVEY: Should I move these ME Super Project notes to a separate blog? This was suggested by a rare write-in viewer. So, how do you ... -
So the next bit is the "Relay P. C." This part is connected to the speed buttons. The required first thing is to remove the t... -
A question from "Mike"... Inside a 67 200mm f4.0... sad thing is that I don't have one yet... however, we can at least get... -
This is the thing... I started with the camera with the fewer symptoms and hope that once the problems are fixed that it will be closed up...
-
A closer look at the "Winding Guide Plate Assembly"... Indicated is what was corrected. The function it provides is to move, ... -
One out of three... Although the service manual indicates removing the three wires, I opt to only do the one gray wire on the right as n... -
So with some coaxing the face of it falls off. As you can see, busy in there. Camera 1 will be just a basic gooey bumper and some clea... -
to orient, we are looking from the front just over the strap lug of the crank side. Not critical to the operation of the camera, but a ...
Tuesday, August 23, 2011
So what else?
Bid and won another broken camera.... yes it is sad that I should be out shooting, but instead hunched over a disassembled camera.
This is gummed up with bad foam as it shows the symptoms. Much like the MG I repaired a while back. So the trick is to remove some key wires and pop the mirror box out.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment