I'm sorry about this... I tested camera 1 and not demonstrated it.
So I will start by mentioning that the yellow arrows are for the direction that you are to move the levers.
1. Push the post with the slotted head in the direction of the mount.
A. It will move to a locked position and almost nothing else will move.
B. If all the levers start moving at the same time, then the bumper is too big and not allowing the reset to happen.
2. Push the lever in the down direction or towards the bottom of the camera
A. The mirror will fly up to the full open position.
B. Arm moves, but not response. That would be possible that after you installed the bumper that the arm was not re-attached to the other link.
C. Mirror drop immediately or other oddness. Where arrow 3 is located it might be that the lever is not resting in the up position due to gunk sticking it.
3. Push the lever down in the direction towards the bottom of the camera
A. Mirror pops back down and the lever springs back up and all the levers are back to the beginning again.
B. Mirror sluggishly moves. Then another clog or obstruction.
Quick update on the linkage issue earlier... a lever was reversed and if I have time to illustrate it, I'll post it up tomorrow.
So I will start by mentioning that the yellow arrows are for the direction that you are to move the levers.
1. Push the post with the slotted head in the direction of the mount.
A. It will move to a locked position and almost nothing else will move.
B. If all the levers start moving at the same time, then the bumper is too big and not allowing the reset to happen.
2. Push the lever in the down direction or towards the bottom of the camera
A. The mirror will fly up to the full open position.
B. Arm moves, but not response. That would be possible that after you installed the bumper that the arm was not re-attached to the other link.
C. Mirror drop immediately or other oddness. Where arrow 3 is located it might be that the lever is not resting in the up position due to gunk sticking it.
3. Push the lever down in the direction towards the bottom of the camera
A. Mirror pops back down and the lever springs back up and all the levers are back to the beginning again.
B. Mirror sluggishly moves. Then another clog or obstruction.
Quick update on the linkage issue earlier... a lever was reversed and if I have time to illustrate it, I'll post it up tomorrow.
No comments:
Post a Comment